W-10 , W150 Series
1 HP－1.5 HP Sewage Pumps
- 2" Solids Handling
- 2" NPT Discharge
- Heavy Duty Lip & Mechanical Seals in Tamdem
- 230 Volt in Single Phase
- 230 and 460 Volt-Three Phase
- 50 Hz & 60Hz
- Two Chamber Motor Housing
- SeperateCordcap Assembly
- Internal Capcitors-No Control Box Required
- Ductile Iron-Clog-Free, Recessed Impeller
- Silicon Carbide-Mechanical Seal-Grit and Sand Resistant Secondary Lip Seal in Tandem for added Protection
- All Stainless Steel Fasteners
- All Cast & Iron-Clog-Free, Recessed Impeller
Features / Benefits
- Impeller
- Ductile Iron Casting for Superior strength and long Life
- Recessed Design-Provides non-overloading Performance
- Recessed Design-Reduces bearing load / Increases Bearing Life
- Recessed Design-Prevents clogging of Volute & Discharge
- Shaft Seals
- Full Mechanical (Silicon carbide / Silicon Carbide ) with Secondary Lip Seal in Tandem
- Motor
- Permanent Split Capacitor design for Single Phase models Features Lower Starting Currents,While maintaining Excellent Starting Torque
- Capacitor is mounted internally- No External start switches or Capacitors
- Thermol overload is mounted directly on the windings in the single Phase models, for Maximum Temperature sensing
- Stator is Pressed into the cast Iron motor Housing for excellent stator alignment and for superior Heat transfer from the Windings to the fluid being Pumped
-
- Oil-filled provides:
-
- Constant Bearing lubrication.
- maximum Motor cooling (oil conducts heat from Motor Windings to the Fluids being Pumped)
- Helps provide even heat distribution, throughout the motor housing, Providing even heat Convection, thus Aiding to eliminate(hot Spots Zones) as experienced in Air filled motors, Air has a very low Coefficient for transferring heat
TOP