SPE3 Series

1/3 HP Effluent Pumps

SPE3

1/3 HP Effluent Pumps

  • 1/2" Solids Handling
  • Heavy Duty Lip & Mechanical Seals in Tandem
  • 115 & 230 Volts available
  • 50 Hz & 60Hz
  • Durable Cast Iron Motor Housing
  • 115 & 230 Volt Piggyback Power Plug and Switch Plug w/20' Cord as Standard
Download PDF Format

Features / Benefits

Impeller
Recessed (Vortex) design- reduces bearing load & Increases Bearing Life.
Recessed design helps to prevent clogging of Pump.
Material is High Temperature, Corrosion Resistant, Glass filled Nylon for Extra Strength and Durability.
Shaft Seals
Full Mechanical Seal (Carbon / Ceramic).
Lip Seal in Tandem W/ Mechanical Seal for redundant Shaft Sealing and additioual Sealing Protection For the Motor
Bearings
Dual（upper & lower）Ball Bearings-Far superior to" ball/sleeve" and" Sleeve/Sleeve" Bearing designs
Pump Motor Housing
Rugged All Cast Iron Material
Features Execellent Heat Conduction from the motor to the Fluid being Pumped for longer Motor Life
Power Cords
Are Triple Sealed-using, Cord connector, Epoxy Potted with individual conductors stripped internally and Epoxy Sealed around each conductor, to seal and prevent wicking leaks
Motor
Permanent Split Capacitor design –Features Lower starting Currents W/ higher starting Torque, Lower Starting current gives longer Life to Level con trol switches
Capacitor is mounted internally, No start Switch or Coutrol Box is Required
Thermol overload is mounted directly on the Windings for Preventing Motor Failure due to excessively high Motor Temperatures to motor Windings
Oil-filled provides:
  1. Constant Bearing lubrication.
  2. maximum motor cooling (conducts heat from motor to the Fluids being Pumped)
  3. Helps provide even Heat distribution, throughout the motor housing, Helping to eliminate"hot Spots" as seen in Air filled motors, which has a very low Coefficient for Heat Transfer!
TOP