E150
1 1/2 HP Effluent Pumps
- 3/4" Solids Handling
- Heavy Duty Lip & Mechanical Seals in Tandem
- 115 and 230 Volt-Single Phase
- 230 and 460 Volt-Three Phase
- 50 Hz & 60Hz
- Two Chamber Motor Housing
- Separate Cord Cap Assembly
- Internal Capacitors-No Control Box Required
- Ductile Iron-Clog-Free Recessed Impeller
- Silicon Carbide-Mechanical Seal-Grit and Sand Resistant
- Secondary Lip Seal in Tandem-for added protection
- All Cast Iron construction with Stainless Steel Fasteners
Features / Benefits
- Impeller
- Ductile Iron Casting for Superior strength and long. Life
- Recessed Design-provides non-overloading performance
- Recessed Design-reduces bearing load/Increases Bearing Life
- Recessed Design-Prevents Clogging
- Shaft Seals
- Full Mechanical (Silicon Carbide/Silicon Carbide) With Secondary Lip Seal in Tandem .
- Motor
- Permanent split capacitor design for single Phase modelsFeatures Lower Starting Currents, while maintaining Execellent Starting Torque
- Capacitor is mounted in ternally-No External start Switches or Capacitors.(Note Single Phase models can be wired directly to Float Switches)
- Thermol over load is mounted directly on windings in the single Phase models for maximum Temperature Sensing Thus Preventing motor failure due to excessively high motor Temperatures
- Stator is Pressed in the motor Housing for execellent Stator Alignment and Superior Aid to Heat transfer from Motor Windings
- Oil-filled provides
- Constant Bearing Lubrication.
- Maximum Motor cooling (Conducts heat from Motor Windings to Fluids Being Pumped)
- Helps provide even heat distribution, throughout the motor Housing, Aiding to eliminate(Hot Spot Zones) as seen in Air filled motors, Air has a very low Coefficient for Tranferring heat.
TOP