NW20- 3021 3043 -V ( H) -50Hz


Features / Benefits

  • Ductile Iron Casting for Superior strength and long Life
  • Recessed Design-Provides non-overloading Performance
  • Recessed Design-Reduces bearing load / Increases Bearing Life
  • Recessed Design-Prevents clogging of Volute & Discharge
Shaft Seals
  • Full Mechanical (Silicon carbide / Silicon Carbide ) with Secondary Lip Seal in Tandem.

  • Permanent Split Capacitor design for Single Phase models Features Lower Starting Currents, While maintaining Excellent Starting Torque
  • Capacitor is mounted internally-No External start switches or Capacitors
  • Thermol overload is mounted directly on the windings in the single Phase models, for Maximum Temperature sensing
  • Stator is Pressed into the cast Iron motor Housing for excellent stator alignment and for superior Heat transfer from the Windings.
Oil-filled provides
  • Constant Bearing Lubrication.
  • Maximum Motor cooling (Conducts heat from Motor Windings to Fluids Being Pumped)
  • Helps provide even heat distribution, throughout the motor Housing, Aiding to eliminate(Hot Spot Zones) as seen in Air filled motors, Air has a very low Coefficient for Tranferring heat.



NW20 – V (H) - 50Hz
3HP Sewage Pumps
  • 2" Solids Handling
  • 2" & 3" NPT Vertical Discharge
  • 3" Horizontal Flanged Discharge
  • Heavy Duty Lip & Mechanical Seals in Tamdem
  • 240 Volt in Single Phase 50Hz
  • 415 Volt-Three Phase 50Hz
  • Two Chamber Motor Housing
  • Separate Cord cap Assembly
  • Internal Capcitors -No Control Box Required
  • Ductile Iron-Clog-Free, Recessed Impeller
  • Dual Mechanical Seal –Carbon / ceramic motor side silicon Carbide / Silicon Carbide Seal Plate side
  • Secondary Lip Seal in Tandem for added Protection
  • All Stainless Steel Fasteners
  • All Cast & Iron-Clog-Free, Recessed Impeller

Back to Previous Page